nixpkgs/nixos/doc/manual/administration/declarative-containers.xml

61 lines
2.2 KiB
XML
Raw Normal View History

<section xmlns="http://docbook.org/ns/docbook"
xmlns:xlink="http://www.w3.org/1999/xlink"
xmlns:xi="http://www.w3.org/2001/XInclude"
version="5.0"
xml:id="sec-declarative-containers">
<title>Declarative Container Specification</title>
<para>You can also specify containers and their configuration in the
hosts <filename>configuration.nix</filename>. For example, the
following specifies that there shall be a container named
<literal>database</literal> running PostgreSQL:
<programlisting>
containers.database =
{ config =
{ config, pkgs, ... }:
{ services.postgresql.enable = true;
services.postgresql.package = pkgs.postgresql92;
};
};
</programlisting>
If you run <literal>nixos-rebuild switch</literal>, the container will
be built. If the container was already running, it will be
2015-12-10 18:17:06 +00:00
updated in place, without rebooting. The container can be configured to
start automatically by setting <literal>containers.database.autoStart = true</literal>
in its configuration.</para>
<para>By default, declarative containers share the network namespace
of the host, meaning that they can listen on (privileged)
ports. However, they cannot change the network configuration. You can
give a container its own network as follows:
<programlisting>
containers.database =
{ privateNetwork = true;
hostAddress = "192.168.100.10";
localAddress = "192.168.100.11";
};
</programlisting>
This gives the container a private virtual Ethernet interface with IP
address <literal>192.168.100.11</literal>, which is hooked up to a
virtual Ethernet interface on the host with IP address
<literal>192.168.100.10</literal>. (See the next section for details
on container networking.)</para>
<para>To disable the container, just remove it from
<filename>configuration.nix</filename> and run <literal>nixos-rebuild
switch</literal>. Note that this will not delete the root directory of
the container in <literal>/var/lib/containers</literal>. Containers can be
destroyed using the imperative method: <literal>nixos-container destroy
foo</literal>.</para>
2015-03-11 14:29:55 +00:00
<para>Declarative containers can be started and stopped using the
corresponding systemd service, e.g. <literal>systemctl start
container@database</literal>.</para>
2015-03-10 15:22:50 +00:00
</section>