nixpkgs/nixos/doc/manual/configuration/ipv4-config.xml
2014-08-31 09:46:16 -07:00

45 lines
1.3 KiB
XML
Raw Blame History

This file contains ambiguous Unicode characters

This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

<section xmlns="http://docbook.org/ns/docbook"
xmlns:xlink="http://www.w3.org/1999/xlink"
xmlns:xi="http://www.w3.org/2001/XInclude"
version="5.0"
xml:id="sec-ipv4">
<title>IPv4 Configuration</title>
<para>By default, NixOS uses DHCP (specifically,
<command>dhcpcd</command>) to automatically configure network
interfaces. However, you can configure an interface manually as
follows:
<programlisting>
networking.interfaces.eth0.ip4 = [ { address = "192.168.1.2"; prefixLength = 24; } ];
</programlisting>
Typically youll also want to set a default gateway and set of name
servers:
<programlisting>
networking.defaultGateway = "192.168.1.1";
networking.nameservers = [ "8.8.8.8" ];
</programlisting>
</para>
<note><para>Statically configured interfaces are set up by the systemd
service
<replaceable>interface-name</replaceable><literal>-cfg.service</literal>.
The default gateway and name server configuration is performed by
<literal>network-setup.service</literal>.</para></note>
<para>The host name is set using <option>networking.hostName</option>:
<programlisting>
networking.hostName = "cartman";
</programlisting>
The default host name is <literal>nixos</literal>. Set it to the
empty string (<literal>""</literal>) to allow the DHCP server to
provide the host name.</para>
</section>