nixpkgs/nixos/doc/manual/administration/container-networking.xml
2018-05-01 19:57:09 -04:00

56 lines
2.1 KiB
XML
Raw Blame History

This file contains ambiguous Unicode characters

This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

<section xmlns="http://docbook.org/ns/docbook"
xmlns:xlink="http://www.w3.org/1999/xlink"
xmlns:xi="http://www.w3.org/2001/XInclude"
version="5.0"
xml:id="sec-container-networking">
<title>Container Networking</title>
<para>
When you create a container using <literal>nixos-container create</literal>,
it gets it own private IPv4 address in the range
<literal>10.233.0.0/16</literal>. You can get the containers IPv4 address
as follows:
<screen>
# nixos-container show-ip foo
10.233.4.2
$ ping -c1 10.233.4.2
64 bytes from 10.233.4.2: icmp_seq=1 ttl=64 time=0.106 ms
</screen>
</para>
<para>
Networking is implemented using a pair of virtual Ethernet devices. The
network interface in the container is called <literal>eth0</literal>, while
the matching interface in the host is called
<literal>ve-<replaceable>container-name</replaceable></literal> (e.g.,
<literal>ve-foo</literal>). The container has its own network namespace and
the <literal>CAP_NET_ADMIN</literal> capability, so it can perform arbitrary
network configuration such as setting up firewall rules, without affecting or
having access to the hosts network.
</para>
<para>
By default, containers cannot talk to the outside network. If you want that,
you should set up Network Address Translation (NAT) rules on the host to
rewrite container traffic to use your external IP address. This can be
accomplished using the following configuration on the host:
<programlisting>
<xref linkend="opt-networking.nat.enable"/> = true;
<xref linkend="opt-networking.nat.internalInterfaces"/> = ["ve-+"];
<xref linkend="opt-networking.nat.externalInterface"/> = "eth0";
</programlisting>
where <literal>eth0</literal> should be replaced with the desired external
interface. Note that <literal>ve-+</literal> is a wildcard that matches all
container interfaces.
</para>
<para>
If you are using Network Manager, you need to explicitly prevent it from
managing container interfaces:
<programlisting>
networking.networkmanager.unmanaged = [ "interface-name:ve-*" ];
</programlisting>
</para>
</section>