nixpkgs/nixos/doc/manual/configuration/ipv4-config.xml
2018-05-01 19:57:09 -04:00

44 lines
1.5 KiB
XML
Raw Blame History

This file contains ambiguous Unicode characters

This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

<section xmlns="http://docbook.org/ns/docbook"
xmlns:xlink="http://www.w3.org/1999/xlink"
xmlns:xi="http://www.w3.org/2001/XInclude"
version="5.0"
xml:id="sec-ipv4">
<title>IPv4 Configuration</title>
<para>
By default, NixOS uses DHCP (specifically, <command>dhcpcd</command>) to
automatically configure network interfaces. However, you can configure an
interface manually as follows:
<programlisting>
<link linkend="opt-networking.interfaces._name__.ipv4.addresses">networking.interfaces.eth0.ipv4.addresses</link> = [ {
address = "192.168.1.2";
prefixLength = 24;
} ];
</programlisting>
Typically youll also want to set a default gateway and set of name
servers:
<programlisting>
<xref linkend="opt-networking.defaultGateway"/> = "192.168.1.1";
<xref linkend="opt-networking.nameservers"/> = [ "8.8.8.8" ];
</programlisting>
</para>
<note>
<para>
Statically configured interfaces are set up by the systemd service
<replaceable>interface-name</replaceable><literal>-cfg.service</literal>.
The default gateway and name server configuration is performed by
<literal>network-setup.service</literal>.
</para>
</note>
<para>
The host name is set using <xref linkend="opt-networking.hostName"/>:
<programlisting>
<xref linkend="opt-networking.hostName"/> = "cartman";
</programlisting>
The default host name is <literal>nixos</literal>. Set it to the empty string
(<literal>""</literal>) to allow the DHCP server to provide the host name.
</para>
</section>